killoala.blogg.se

M109r ecu flash
M109r ecu flash








m109r ecu flash
  1. M109R ECU FLASH INSTALL
  2. M109R ECU FLASH FULL
  3. M109R ECU FLASH SOFTWARE

This product comes with 1 Bin File Definition Key allowing you to tune 1 ECU's as many times as you like.User Guides and Installation InstructionsĮlectronic Mapping - Plug and Play Performance

m109r ecu flash

Diagnostics: Read and Clear Fault Codes - (Requires Applicable V3 Interface).Secondary Throttle Plate (STP) Opening Maps.

M109R ECU FLASH SOFTWARE

Purchase this item to gain access in the Woolich Racing Tuned software to the stock bin files for the 2006-2008 Suzuki M109Rįeatures available for Suzuki M109R 2006-2008 You must have a Race Tool Package to use the Pit Speed Limiter Harness.īin File Definitions - for use in Woolich Racing Tuned softwareĢ006-2008 M109R Stock Bin File Definitions The Pit Speed Limiter harness is used with our Race Tools Package, it consists of a harness and water proof push button switch which allows you to limit the RPM of the bike in 1st gear while riding in the pits. *** Pit Speed Limiter harness sold separatelyĢ009-2010 Suzuki M109R Launch Control KeyĢ009-2010 Suzuki M109R Race Tools PackageĢ011-2020 Suzuki M109R Launch Control KeyĢ011-2020 Suzuki M109R Race Tools Package ** This harness uses the stock Exhaust Valve plugs on the bike's harness, the stock Exhaust Valve should be removed from the bike and disabled in our software * Contact us after ordering if you have after-market rearsets or are using a race shift pattern and we will swap the shift rod for a generic rod that can be cut and tapped to the correct length. Pit Speed Limiter allows you to set the RPM to limit the speed while riding through the pits.*** Launch Control allows you to configure Delay, Launch RPM, Ramp Time and Ramp RPM The quickshifter kills both fuel and ignition.

M109R ECU FLASH FULL

Quickshifter Kill times are configurable per gear with 3D maps allowing Kill Times to be set for the full range of TPS and RPM combinations.

  • Race Tools Key to allow the use of the Race Tools on one ECU in the Woolich Racing Tuned software.
  • Suzuki Race Tools Harness Type 1 which allows the quickshifter to be plugged into the bikes wiring harness**.
  • Shift rod for standard shift configuration*.
  • High quality strain gauge Quickshifter with digitally controlled pressure sensing that can be used in regular or race shift pattern.
  • m109r ecu flash

    The Race Tools package allows you to enable Quickshifter, Launch Control and Pit Speed Limiter in the Stock ECU.

    M109R ECU FLASH INSTALL

    If you do not have a Woolich Racing Interface you can also visit a Woolich Racing - Tuning Partner and have them install and configure the Race Tools (additional fees and charges will apply).Ģ006-2008 Suzuki M109R Race Tools Package You can purchase this as a package on the product page for your bike. You will need to use the relevant Woolich Racing Interface and Bin File Definition to enable and configure Race Tools and write to the ECU. Woolich Racing Race Tools requires you to Write the ECU. The Launch Control Key allows you to enable the Launch Control for one ECU. If you already have a Quickshifter or Air Shifter installed on your bike or you only need the Launch Control function you can purchase this Launch Control Key. It allows you to set a Launch RPM and also Ramp Parameters to assist with getting fast consistent launches from your bike, all controlled by the stock ECU. Launch Control is part of the our Race Tools Package. Race Tools: Quickshifter, Launch Control, Pit Speed LimiterĢ006-2008 Suzuki M109R Launch Control Key










    M109r ecu flash